MIL-C-43044C(ME)
3.6 Hydrostatic pressure. The assembled inlet valve body, outlet valve body,
and valve cover shall withstand a hydrostatic pressure of 200 psig for 2 minutes
without leaking, sweating, or visible deformation at any point on the surface.
The control assembly shall be identified in
3.7 Identification marking.
accordance with MIL-STD-130.
3.8 Workmanship. The control assembly shall be free from any defects which
could reduce serviceability. The castings shall be clean, sound, and free from
blowholes, hardspots, porosity, cracks, and other injurious defects. All burrs
and sharp corners shall be removed.
3.9 Recovered materials. For the purpose of this requirement, recovered
materials are those materials which have been collected from solid waste and
reprocessed to become a source of raw materials, as distinguished from virgin raw
materials. The components, pieces and parts incorporated in the control assembly
may be newly fabricated from recovered materials to the maximum extent
practicable, provided the control assembly produced meets all other requirements
of this specification. Used, rebuilt or remanufactured components, pieces and
parts shall not be incorporated in the control assembly.
3.10 Human factors engineering. The control assembly shall conform to human
engineering criteria as described in MIL-STD-1472, paragraphs 4 (General
Requirements), 5.4 (Controls), 5.5 (Labeling), 5.6 (Anthropometry), 5.9 (Design
in Maintainability), and 5.13 (Hazards and Safety).
4.
QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection. Unless otherwise specified in the contract
or purchase order, the contractor is responsible for the performance of all
inspection requirements as specified herein. Except as otherwise specified in
the contract or purchase order, the contractor may use his own or any other
facilities suitable for the performance of the inspection requirements speci-
fied herein, unless disapproved by the Government. The Government reserves the
right to perform any of the inspections set forth in the specification where such
inspections are deemed necessary to assure supplies and services conform to
prescribed requirements.
4.1.1 Component and material inspection. The contractor is responsible for
insuring that components and materials used are manufactured, examined, and
tested in accordance with referenced specifications and standards as applicable.
4.1.2 Responsibility for compliance. All items must meet all requirements of
sections 3 and 5. The inspections set forth in this specification shall become a
part of the contractor's overall inspection system or quality program. The
absence of any inspections requirements in the specification shall not relieve
the contractor of the responsibility of assuring that all products or supplies
submitted to the Government for acceptance comply with all requirements of the
contract. Sampling in quality conformance does not authorize submission of known
defective material, either indicated or actual, nor does it commit the Government
to acceptance of defective material.
4
.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business