A-A-50470 Oilers, Hand, FillerThis CID covers the requirements for filler hand oilers intended to be used for filling large oil cups on heavy machinery with heavier oils, such as 30 or 40 grade. The oiler shall be similar to figure 1 and shall be of either cold-rolled steel or copper as specified in the contract or order. The oiler shall consist essentially of a one-piece seamless body with attached bottom, handle, spout, cap, and chain, when specified in contract or order. The oiler shall comply with the requirements of table 1 for the size as specified in the contract or order.

Pages 1 - 2 - 3 - 4 - 5

[INCH-POUND]

A-A-50470B

June 21, 1993

SUPERSEDING

A-A-50470A

April 11, 1989

COMMERCIAL ITEM DESCRIPTION

OILERS, HAND, FILLER

The General Services Administration has authorized the use of this commercial item description in preference to Federal Specification GGG-0-591, type III.

Abstract. This CID covers the requirements for filler hand oilers intended to be used for filling large oil cups on heavy machinery with heavier oils, such as 30 or 40 grade. The oiler shall be similar to figure 1 and shall be of either cold-rolled steel or copper as specified in the contract or order. The oiler shall consist essentially of a one-piece seamless body with attached bottom, handle, spout, cap, and chain, when specified in contract or order. The oiler shall comply with the requirements of table I for the size as specified in the contract or order.

TABLE I. Filler hand oiler dimensions.

Size Code	Capacity	Diameter (A)			Height (B)			Spout length (C)
	Minimum	Minimum	Maximum		Minimum	Maximum		Minimum	Maximum
	Fluid ounce	Inches			Inches			Inches
1	14	4		5	3		4	4		6
2	30	4-1/8		6	4		5-7/8	5-1/2		8
3	56	5-1/4		7	5		6-5/8	5-1/2		8

Salient characteristics.

1. Body. The metal composing the top section and bottom of the body shall be not less than 0.025 inch thick. The top and bottom shall be joined securely to afford a strong and leakproof construction. A bushing shall be provided in the top of the body to be threaded for securing the cap.

Beneficial comments (recommendations, additions, deletions) and any pertinent data which may be of use in improving this document should be addressed to: Commanding Officer (Code 156), Naval Construction Battalion Center, 621 Pleasant Valley Road. Port Hueneme. CA 93043-4300.

DISTRIBUTION STATEMENT A. Approved for public release; distribution is unlimited.