A-A-50470 Oilers, Hand, FillerThis CID covers the requirements for filler hand oilers intended to be used for filling large oil cups on heavy machinery with heavier oils, such as 30 or 40 grade. The oiler shall be similar to figure 1 and shall be of either cold-rolled steel or copper as specified in the contract or order. The oiler shall consist essentially of a one-piece seamless body with attached bottom, handle, spout, cap, and chain, when specified in contract or order. The oiler shall comply with the requirements of table 1 for the size as specified in the contract or order.

Pages 1 - 2 - 3 - 4 - 5

A-A-50470B

CID based part identification number (PIN). The following PIN procedure is for Government purposes and does not constitute a requirement for the contractor. The PIN to be used for oilers acquired to this CID is created as follows:

A505470-X

A50470- CID part number

X- Size code

1. Size code. The size code of the oiler, relative to its capacity, is identified by a single number (see table 11).

TABLE II. Size code to capacity.

Size code	Capacity, minimum
1	14 fluid ounce
2	30 fluid ounce
3	56 fluid ounce

2. Cross-referencing of PIN. The PIN of oilers in this CID differs from the previous edition in the following respects:

A-A-50470A	A-A-50470B
Finish number	Finish
1. Polished w/clear lacquer or varnish.	Not designated.
2. Brass coated w/clear lacquer varnish.	Not designated.
3. Copper coated w/clear or varnish.	Not designated.
4. Lacquered w/opaque lacquer.	Not designated.
5. Nickel plated.	Not designated.
6. baked enamel finish.	Not designated.
Material number	Material
1. Cold rolled steel	Not designated.
2. Copper.	Not designated.
Size number	Size Code
1. 1 pint.	1-14 fluid ounce
2. 2 pints.	2-30 fluid ounce
3. 4 pints.	4-56 fluid ounce