MIL-C-22587B
4.3.2 Retention of qualification. The retention of qualification of
products approved f or listing on the e Qualified Products List (QPL) shall be
maintained by periodic verification to determine compliance of the qualified
product with the requirements of this specification. Unless otherwise
specified by the activity responsible for the Qualified Products List,
periodic verification shall be by certification and such certification shall
be at intervals of not more than-two years.
4.4 Quality conformance inspection. Quality conformance
inspection shall consist of a visual examination to determine compliance with
the materials, design and construction, and workmanship requirements of the
Quality conformance inspection shall also include the
specification.
operation and grease retention after operation tests of Table I and the
physical measurement test of 4.6.1.
4.4.1 C e r i f i c a t i o n .
The manufacturer shall certify that there
has been no manufacturing or process change from that which resulted in the
production of the qualification samples (see 6.4).
4.4.2 Inspection lot size. Unless otherwise specified, a lot
shall consist of all the grease cartridges of one type fabricated from the
same materials by the same manufacturing process and submitted for inspection
at one time as part of one contract or order.
4.4.2.1 Sampling and inspection procedures. A random sample of
cartridges shall be selected from each inspection lot in accordance with
The sample size shall be based on the applicable sample size
MIL-STD-105.
code letter using Table IIIA, Inspection level II.
Defects found during
4.4.2.1.1 Classification of defects.
inspection shall be classified as follows:
Major Defects
(AQL shall be 4.0 percent defective)
101.
Overall dimensions not within specified tolerances.
102.
Defective component parts which affect operation.
103.
Omission of a component part.
104.
Defective cartridge inner liner.
105.
Binding of the grease gun or separation of the interior plies.
106.
Grease retention of more than 5.0 percent of original weight
after operation.
Minor Defects
(AQL shall be 10.0 percent defective)
201
Improper fit of end closures.
202.
Identification markings not as specified.
Packaging not as specified.
203.
Packing not as specified.
2040
205.
Marking illegible or not as specified.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business