A-A-50202A
3.2 Performance. The pumps shall meet the performance requirements of Table I while using the following lubricants:
Type I - use lubricant conforming to MIL-PRF-10924
Type II - use grade SAE 75W or SAE 80W-90 gear lubricant conforming to SAE J2360
Table I. Pump performance requirements.
Function |
Type I |
Type II |
Minimum rate of discharge (at 70 °F) Minimum rate of discharge (at 0 °F) Minimum rate of discharge (at minus (-) 25 °F) Minimum rate of discharge (at back pressure of 5000 pounds per square inch gauge (psig) at 70 °F) Maximum static pressure developed by pressure pump (at all specified temperatures) |
8 ounces (oz.) per minute with maximum of 50 strokes 7 oz. per minute with maximum of 50 strokes 4 oz. per minute with maximum of 50 strokes 1 oz. in not more than 30 seconds with continuous pumping 7000 psig |
2.5 pounds (lb.) per minute with maximum of 50 strokes 1.75 lb. per minute with maximum of 50 strokes 1 lb. per minute with maximum of 50 strokes No requirement 500 psig |
3.3 Identification and marking. Each pump shall be marked for identification with the National
Stock Number (see 7.3).
4. REGULATORY REQUIREMENTS
4.1 Recovered material. The offeror/contractor is encouraged to use recovered materials to the maximum extent practicable, in accordance with paragraph 23.403 of the Federal Acquisition Regulation (FAR).
5. PRODUCT CONFORMANCE PROVISIONS
5.1 Responsibility for inspection. The contractor is responsible for the performance of all inspections (examinations and tests).
5.2 Contractor certification. The contractor shall certify and maintain substantiating evidence that the product offered meets the salient characteristics of this CID and that the product conforms to the producer's own drawings, specifications, workmanship standards, and quality assurance practices. Items with known defects shall not be submitted for Government
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business