XX-D-370 Dispensing Pump, Hand Driven, Drum, 1 Quart Oil, For 15- To 55 Gallon DrumsThis specification covers a hand-operated pump, hereafter called ??pump unit?? for dispensing 1 quart of oil per cycle from 15- to 55-gallon drums.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13

3.8  Identification marking.

XX-D-370D

3.8.1  Military agencies.  The pump shall be identified in accordance with MIL-STD-130.  The marking shall be applied to the pump unit on plates conforming to MIL-P-15024/6, type B,

style III.  Plates shall be attached by screws, bolts, or rivets in a conspicuous protected location.

3.8.2  Civil agencies.  The pump unit shall have the contractor's standard commercial identification marking.

3.9  Treatment and painting.  The portions of the pump unit normally painted shall be cleaned, treated, and painted in accordance with MIL-T-704, type A. Unless otherwise specified

(see 6.2.1), the color shall be in accordance-with Fed. Std. No. 595, color No. 24087.

3.10  Workmanship.

3.10.1  Castings and forging.  All parts, components, and assemblies of the pump unit which include castings and forgings shall be clean of harmful extraneous material such as sand, dirt, sprues, scale, and flux.  Rework shall be limited to procedures which do not reduce strength or affect function.

4.  QUALITY ASSURANCE PROVISIONS

4.1   Responsibility for inspection.  Unless otherwise specified in the contract or purchase order, the contractor is responsible for the performance of all inspection requirements as specified herein.  Except as otherwise specified in the contract or purchase order, the contractor may use his own or any other facilities suitable for the performance of the inspection requirements

specified herein, unless disapproved by the Government.  The Government reserves the right to perform any of the inspections set forth in the specification where such inspections are deemed necessary to assure supplies and services conform to prescribed requirements.

4.1.1  Component and material inspection.  The contractor is responsible for insuring that components and materials used are manufactured, examined, and tested in accordance with referenced specifications and standards.

4.2  Classification of inspections.  Inspections shall be classified as follows:

a.   First article inspection (see 4.3).

b.   Quality conformance inspection (see 4.4).

c.   Examination of preparation for delivery (see 4.6).

7